How do you clean the filter on a Shark Navigator?


clean the filter on a Shark Navigator



A filthy vacuum is less proficient than a perfect one. At the point when the channels get to distinctly blocked, it diminishes the suction control colossally. You additionally need to ensure that the turning brush on the base is clear of materials that get to distinctly wrapped around it after some time.

Signs that your Shark Navigator needs cleaning:

  • There’s lost suction
  • It’s deserting soil
  • It sounds not the same as would be expected
  • The vacuum leaves an obnoxious smell

If you are encountering any, or the greater part of the issues above you will need to give your vacuum a genuinely necessary cleaning. Along these lines, you can at the end of the day appreciate the advantages of a perfect home.

Cleaning the Rotating Brush

  • A decent place to begin is with the turning brush underneath the vacuum.
  • To begin with and in particular, ensure your vacuum is unplugged!
  • Lay it down on the floor. You might need to put a sack underneath to keep an undesirable wreckage.
  • You need to expel any material that has wrapped around the brush, such as string and hair.
  • When all the flotsam and jetsam clear, you finish with this progression!


The Shark Navigator is a bagless framework. The greater part of the earth that is grabbed is put away in a removable plastic compartment for simple transfer. It is a zone of the vacuum that needs to be cleaned. The channel framework can get to be distinctly blocked making you lose suction control.

  • Expel the soil holder and discharge any earth particles into the waste.
  • Open the highest point of this compartment and expel the channel framework.
  • Vacant and grimy or clean particles out of the channel by delicately tapping for your junk can.
  • When all the free soil is discharged you can start cleaning these parts with water. (I utilize plain faucet water to clean mine.)
  • When flushing the plastic channel framework, you should continue showering with water until the water tells the truth appearance. Flush the earth holder completely.


Note: Allow time for it to dry totally. You’ll have to permit sufficient drying time (and you would prefer not to work a vacuum if it’s as yet wet!) Lay every one of the parts out independently to dry. When everything is dry, you can assemble them back.

More at :


Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )


Connecting to %s